Intec K30000-01 Guida di Installazione Scaricare il pdf (Pagina 17)

OPERATIONAL GUIDELINES

FORCE

/3 3.0 & 4.0 DP

Operational Guidelines

BLOWING SIDEWALLS, CELLULOSE:

When blowing sidewalls, use the following settings and recommen-

dations as guidelines. Settings may change from job to job, material

to material, or nozzle to nozzle. Hose length and humidity may

affect your results.

Two hole method, standard wall construction: 2" x 4" x 16" on

center. Air setting 100%

Hole size Slide gate opening

2" 4"

1" 2"

5/8" 1"

Keeping the material level consistent in the hopper will aid in

achieving good sidewall densities. A gradual transition in hose size

will aid in the material flow and help eliminate clogging. Start at the

machine with 50' of 3" hose, connect 50' of 2-

⁄2" next and then

connect 50' of 2". Use hose reducers and clamps to connect the

hose making sure all connections are tight. If clogging or less than

satisfactory compaction occurs, adjust the slide gate inward by

⁄2"

increments until the situation clears. If the problem persists, add an

additional 50' of 2" hose and readjust the slide gate setting,

maximum hose length, 200 feet.

BLOWING SIDEWALL (DENSE-PAK):

Drill two holes into the wall, one 17" (approx) from the bottom and

one 17" (approx) from the top of the cavity. Always use the largest

hole possible to prevent clogging. Starting with the bottom hole,

put the insulation nozzle into the hole, using the remote, turn the

blower on first, then the agitator

. Fill the cavity until the material

stops flowing, tur

n of

f the agitator and allow the blower to push

additional material into the wall. T

n of

f the blower and wait until

essur

e in line has dissipated befor

e r

emoving the insulation

nozzle. Repeat the steps for filling the cavity thr

ough the top hole.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Commenti su questo manuale

Nessun commento

Intec K30000-01 Guida di Installazione Pagina 17

Commenti su questo manuale